• Shark Steam Mop S3101 Instructions
• Shark Steam Mop User Manual
• Shark Steam Mop S3101 How To Use
• Shark Steam Mop S3101 Manual
• Shark Steam Mop S3101 Instructions Manual

Nov 22, 2015  shark light and easy steam mop review, shark light and easy steam mop bed bath and beyond, shark light and easy steam mop replacement pads, shark light and easy steam mop manual, shark.

OPERATING INSTRUCTIONS

7

Care and Maintenance

• Shark S3101 N User Manual. Operating instructions. Shark Vacuums. Manuals Directory ManualsDir.com - online owner manuals library. Shark manuals. Using the Steam Mop. IMPORTANT: Never use the steam mop without the micro-fiber cleaning pad attached to the mop head or without water in the water tank.
• Now you're reading a user guide for Shark Carpet Cleaner S3101 N. This manual is encoded in PDF file format The PDF (Portable Document Format) was created in the early 1990’s as a brand new way for computer users to share documents between each other, especially if.
• The powerful steam in Shark®'s Original Steam Mop leaves floors clean and sanitized. Unlike traditional mopping, the Original Steam Mop requires no mop, no bucket and leaves floors virtually dry. Quick, Easy, and Lightweight; Chemical Free & Ready to Use in 30 Seconds. Safe on all Sealed Hard Floor Surfaces; Powerful Steam leaves floors.

If you consistently use distilled water,
cleaning the water tank is unnecessary.

CAUTION:

This appliance must be

unplugged from the electrical outlet
before performing any cleaning or
maintenance tasks on the unit.

Rinsing Out the Steam Mop

1. Let the appliance cool down

completely before cleaning or storing.

2. Empty all water from the water tank

after each use.

Water

•

Use tap water for all your cleaning
needs.

•

However, if you live in an area with
hard water, it is recommended that
you use distilled water

IMPORTANT:

Do NOT add cleaning

solutions, scented perfumes, oils or any
other chemicals to the water used in this
appliance, as this may damage it or
make it unsafe for use. Use distilled
water if the tap water in your area is
very hard.

Helpful Hints

1. Always vacuum or sweep before using

the steam mop.

2. The easiest way to use the steam mop

is to tilt the ergonomic handle to a 45°
angle and clean slowly.

3. Hand wash or machine wash the

micro-fiber cleaning pad in a delicate
cycle with a mild liquid detergent.

4. We recommend air drying the micro-

fiber cleaning pads for 24 hours, but
they could be dried in a dryer on a low
heat setting.

5. A good amount of steam passes

through the micro-fiber cleaning pad.
We recommend that the cleaning pad
be changed when it gets too wet.
These need to be replaced as
necessary.

6. To remove stubborn stains from vinyl

or linoleum floors, pre-treat with a mild
detergent and some water before
using the steam mop.

Dewalt dwe7491rs Pdf User Manuals. View online or download Dewalt dwe7491rs Instruction Manual. Manuals; Brands; DeWalt Manuals; Saw; dwe7491rs; Dewalt dwe7491rs Manuals Manuals and User Guides for DeWalt dwe7491rs. We have 1 DeWalt dwe7491rs manual available for free PDF download. (254 mm) Job Site Table Saw with Guard Detect. Get DEWALT DWE7491RS Use and Care Manual. Get all DEWALT manuals! Sign up to create an account. A kickback occurs when a part of the workpiece binds between the saw blade and the rip fence, or other fixed object, and rises from the table and is thrown toward the operator. Kickbacks can be avoided by attention to the. Dewalt table saw dwe7491rs. The DWE7491RS 10' Jobsite Table Saw 32 - 1/2' Rip Capacity, and a Rolling Stand has a 15 Amp motor and 32-1/2' rip capacity to allow cutting of large and hardwood materials. Features tool-free guarding component adjustments and fast, accurate fence adjustments. Rolling stand designed for easy set up and breakdown with excellent stability. Dewalt DWE7491 Manuals Manuals and User Guides for DeWalt DWE7491. Heavy-Duty 10' (254 mm) Job Site Table Saw with Guard Detect. DeWalt DWE7490; DeWalt dwe7491rs; DEWALT DWE575; DEWALT DWE575SB; DeWalt DWE357-XE; DeWalt DWE397; DeWalt Categories.

IMPORTANT:

Never leave the steam

mop in one spot on any surface for any
period of time with a damp or wet
micro-fiber cleaning pad attached as
this will damage your floors.

TROUBLE SHOOTING

PROBLEM POSSIBLE

CAUSE POSSIBLE

SOLUTION

STEAM MOP
WILL NOT
OPERATE

1. Power

cord

not

firmly

plugged into outlet.

2. No power in wall outlet.
3. Needs

servicing.

1. Plug unit in firmly.
2. Check fuse or breaker.

Replace fuse/reset
breaker.

3. Call 1 (800) 798-7398.

STEAM MOP
WILL NOT MAKE
STEAM

1. No water in water tank.

1. Add water to the water

tank following
instructions.

STEAM MOP
LEAVES WATER
ON THE FLOOR

1. Micro-fiber

cleaning

Shark Steam Mop S3101 Instructions

pad

is

too wet.

1. Unplug

unit

from

power

outlet and change the
micro-fiber cleaning pad.

STEAM MOP
LEFT WHITE
SPOT ON
FLOOR

1. Steam mop left in one

spot too long.

2. Hard

water.

1. Never leave the steam

mop on the floor with a
damp or wet cleaning
pad still attached when
not in use.

2. Use

distilled

water.

To Order Replacement Micro-Fiber Pads

for Models

S3101 N - S3101W N

Item # XT3101

Call: 1 (800)798-7398

Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time

Or visit our website: www.sharkcompany.com

FOR TECHNICAL SUPPORT
for Models

S3101 N - S3101W N

Call: 1 (800) 798-7398

Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time

8

Pump

actuator

Fig. 1

How To Assemble Your Steam Mop

1. Remove all the parts from the

packaging.

2. Insert the upper extension

tube into the lower
telescopic tube. (Fig. 1)
Push it in until you
hear it click into place.

3. Insert the extension

tube assembly into the
pump actuator. Make
sure that the locking
tab snaps into place.
(Fig. 1)

4. Place the micro-fiber

cleaning pad underneath
the mop head. Make
sure that the hook
and latch strips are
facing up. (Fig. 2)
Press to secure.

TIP:

The micro-fiber

cleaning pads have
a colored tab so that
a different pad can
be assigned to
different tasks or
rooms in the
house.

Fig. 3

Shark Steam Mop User Manual

Fig. 2

Mop

head

Hook & latch

strips

5

OPERATING INSTRUCTIONS

Using the Steam Mop

IMPORTANT: Never use the steam mop
without the micro-fiber cleaning pad
attached to the mop head or without water
in the water tank.
Please note that when using for the first
time, the appliance may take longer than
the normal 30 second startup time to
steam. You may need to pump the handle
a few times before the steam is released.
This is due to the water making its way
from the water tank through the pump and
into the heater. This will only occur during
the first use.
1. Sweep or vacuum floors before using

the steam mop.

2. Twist the quick release cord holder to

unwrap the power cord completely.

3. Plug into a 120-volt electrical outlet.
4. The power “On” light will turn green.
5. It takes approximately 30 seconds for

the unit to heat up and the steam to be
ready.

6. Pump the handle a few times to

dampen the micro-fiber cleaning pad.
Begin mopping with a forward and
backward motion, this pumping action
will release steam as you mop.

Fig. 4

MAX

Filling the Water Tank
IMPORTANT:

Always insure that the

unit is “UNPLUGGED” from the wall
receptacle prior to filling and before
attaching the micro-fiber cleaning pad to
the bottom of the mop head. Never use
the steam mop without the micro-fiber
cleaning pad attached to the mop head.
NOTE: When using your new steam mop
for the first time you may notice water
residue inside of the unit. Water drops
can also be found in the packaging. This
is normal and you should not be alarmed.
Each steam mop is 100% tested in the
factory to ensure product performance
and safety. Sometimes
water is left in the unit
from these test procedures.
1. Turn the cap

counter clockwise
and then lift up to
remove from the
water tank. (Fig. 4)

2. Using the filling flask and funnel, pour

one flask of water into the water tank.
Do not overfill the unit past the “MAX”
fill line on the water tank. (Fig. 4)

3. Replace the cap onto the water tank.

To Extend the Telescopic Tube

1. Lift the locking latch up 90°.

(Fig. 3)

2. Holding the handle, extend the

telescopic tube to the desired
length. (Fig. 3)

3. When you have the telescopic

tube to the length that you
want, close the locking latch.

HELPFUL HINT: If you find
the Steam Mop difficult to
push/pull during use, then
simply increase the height
of the pole.

OPERATING INSTRUCTIONS

7. When the water tank is empty, the

steam mop will stop emitting steam.
Unplug the power cord from the
electrical outlet and refill the water tank
following the instructions above.

8. When you have finished using the

steam mop, unplug the unit from the
electrical outlet and carefully remove
the micro-fiber cleaning pad from the
mop head. Please note that the micro-
fiber cleaning pad gets very hot with
the steam. Always use caution when
removing.

9. Never leave the micro-fiber cleaning

pad on the steam mop head when
you have finished using the steam
mop. Always remove the micro-fiber
cleaning pad and wash in warm water
with a mild detergent. Never use
bleach or fabric softener when
washing the reusable micro-fiber
cleaning pad. The micro-fiber cleaning
pad may be washed in a washing
machine and dried in a clothes drier on
low heat. We recommend that you air
dry.

IMPORTANT

: Be careful when machine

washing or drying with mixed fabrics as
micro-fiber pads will pick up lint from other
fabrics and the hook and latch strips will
stick to other garments. We recommend
washing the micro-fiber cleaning pads
separately or placing them in a garment
bag first.

CAUTION:

Never store the steam mop

with a wet or damp micro-fiber
cleaning pad still attached as this will
damage your floors.

Care & Maintenance of the Micro-
Fiber Cleaning Pad

Due to the unique cleaning ability of this
pad, proper care of your micro-fiber
cleaning pad is required to ensure long
life and continued cleaning ability.
• The first thing you should do when you

get a new micro-fiber cleaning pad is
to wash and dry it. During the
manufacturing process the fabric has
a tendency to become flat as it picks
up contaminants from the air and
machinery. There will also be a number
of loose threads that, while they cause
no harm, can be annoying the first time
you use the pad.

• To wash the micro-fiber cleaning pad,

simply put it in your washing machine
using the warm water setting or hand
wash.

• We recommend washing your micro-

fiber cleaning pads separately from
other fabrics or placing them in a
garment bag first if washing by
machine. They have a tendency to
pick up lint and other particles from
other fabrics and the next time you
use your micro-fiber cleaning pad, this
lint will transfer to the surface being
cleaned.

• ONLY USE LIQUID DETERGENTS,

never use dry detergents as many
times the granules do not fully
dissolve and become trapped in the
cleaning pad. This can scratch the
surface that you are cleaning.

• NEVER USE BLEACH OR FABRIC

SOFTENERS! Bleach will damage the
micro-fiber fabric and fabric softeners
deposit a coating on the micro-fiber
fabric what will not allow the pad to
clean efficiently.

• We recommend that you air dry the

micro-fiber cleaning pad. If using a
clothes dryer, do not put on a high
heat setting as high heat will cause
the micro-fiber pad to shrink and the
micro-fibers to break down.

• Wash the micro-fiber cleaning pads

regularly and don’t allow them get too
dirty so that they will last much longer.
As with any fabric, dirt particles,
grease and other contaminants can
cause the fibers to break down,
therefore regular cleaning will help
preserve your micro-fiber cleaning
pads.

• As you use the micro-fiber cleaning

pad, you will notice that sometimes a
thread will loosen or pull out. This is
normal and you should NEVER PULL
AT THE LOOSE THREAD! Pulling the
thread can cause the weave to come
undone. Instead, simply trim the
thread with a pair of sharp scissors.

6

Shark Steam Mop S3101 How To Use

Shark Steam Mop S3101 Manual

Shark Steam Mop S3101 Instructions Manual